Brand Name: RadioLink
Item Name: AT10II Transmitter with Receiver
Specification Of the AT10II Transmitter:
|| 2.4GHz ISM band(2400MHz to 2485MHz)
| Modulation Mode
| Channel Bandwidth
| Spread Spectrum
| Adjacent Channel Rejection
| Transmitter Power
|| <100mW(PCB testing),<20dBm(3 meter air testing)
| Operating Current
| Operating Voltage
| Control Distance
|| 800 meters ground
|| 10 Channel
| Simulator Mode
|| Under the simulator model the transmitter action turn off, change to power saving model
|| 16 colorful screen
Size 78 x 52mm
| Compatible Model
|| Include all 120 degree and 90 degree swashplate helicopter,all fix wing and gliders, five flying model.
|| 18 x 9.5 x 22cm
Specification Of R12DS Receiver:
|| 12CH,support SBUS and PWM signal output
| Working Voltage
| Working Current
|| 38-45mA(input voltage: 5V)
| Control Range
|| About 4KM air
(Maximum range tested in unobstructed areas free of interference and may vary depending on local regulations).
Two signal working mode of R12DS:
(1)PWM signal output working mode: red LED indicates PWM signal output, 11 channels Totally.
(2) S-BUS signal output working mode: blue/purple LED indicates S-BUS signal output, 12 channels totally.
S-BUS and PWM signal working at the same time. S-BUS signal channel(3 pin of row 11) output 12 channels S-BUS signal, PWM signal channels(3 pin of row 1 to row 10) output CH3 to CH12 PWM signals, but 12 channel in total. How many PWM signal channels you can use depends on how many S-BUS signal channels you have used(e.g: you have use 4 S-BUS signal channels, then you have 8 PWM signal channels to use).
How to match code with transmitter:
1. Put the transmitter and the receiver close to each other within 1 meters.
2. Turn on the transmitter, then power on the R12DS.
3. Connect CH3 of R12DS to ESC.
4. There is a black button on the R12DS, use a thin stick press the button twice in two seconds, receiver light starts blinking, after about blinking 8 times, match code success and receiver signal LED always on.
Upgraded version of Radiolink AT10,with DSSS and FHSS dual signal
Higher accuracy of anti-interference and transmitter control bars than AT10.
Support English & Chinese Menu
Multiple function remote control system
Including helicopter,airplane and slider three type flying machine and five models,cover almost every popular model,you can fly any model by this radio.
3.5 inch colorful screen 320×480 resolution,clear display menu and graphs.
Fast responses time only 3ms to the operation,faster then the other transmitter 20ms,even ten channels also let you feel it.
High channel resolution reaches 4096,0.25us per resolution let all the servos keep tranquil.
Strong anti-jumping,DSSS(Direct sequence spread spectrum) technology.
Receiver integrate telemetry sensor including signal strength and voltage.
Support extended engine voltage telemetry module PRM-01 can feedback GPS info, Speed, voltage etc. on AT10II display when work with flight controller APM or PIX.
Note: The AT10II transmitter is NOT compatible with R10D receiver.
English Manual,Click Here